C-Bus app control for the system already in your walls: lights, blinds, fans, scenes and schedules — plus hardware that tells you when something is about to fail. Melbourne, bilingual.
No rewiring. No new switches. The same C-Bus — now in your hand.
The switches you already touch — kept, not replaced.
We work on the Clipsal and Schneider C-Bus already in your walls — from 5500PCU interfaces and 5500CN network bridges to 5750WPL dimmers. No rewiring, and no new switch plates unless you want them.
Your C-Bus on iPhone, iPad and Android — lights, blinds, fans, scenes and schedules. The keypads you already touch stay exactly where they are.
Dead circuit, flickering light, module alarm? We measure the bus, read every module and name the failed part — with its serial number.
Failed 5750WPL dimmer, 5750PSU power supply, 5500CN bridge or 5500PCU interface? We source it, fit it, reprogram and label it.
Original installer gone? We read the existing project, rebuild the database where needed and document every room, circuit and scene.
Sunset-to-sunrise schedules with ±20 minutes of variation, so an empty house still looks lived-in — the cheapest security you can install.
A monthly service that watches voltage and trends, checks 51 modules a day and calls you before a light fails — not after.
C-Bus is manufactured by Clipsal / Schneider Electric (now sold as SpaceLogic C-Bus). WIS Living is an independent Melbourne integrator: we keep existing systems running, extend them, and add app control without replacing the backbone.
If you can use a light switch, you can use this.
Your favourites, one tap.
22 rooms, one list.
On, off, dim. Done.
The industry writes off older systems. We reconnect them, diagnose them, and look after them.
The wiring is fine. The modules are fine. What disappeared was the support.
Wired, labelled, built to last. Still switching 47 circuits today.
The app stopped. The dealer moved on. The system kept working — quietly, unnoticed.
Reconnected, diagnosed and looked after. Same wires. New voice.
Back on the network and on your phone, without touching the walls. The system you already paid for becomes useful again.
It measures voltage, modules and communication — then names the failing part and its serial number. No guesswork, no blame.
A monthly service with a phone number, a person, and a call before the light fails — not after.
Every light can follow a schedule — sunset on, sunrise off, or exactly 7:42pm. When you're away, WIS Living keeps the house looking occupied.
Any light, any time. Sunset, sunrise, or a specific minute.
Times shift a little every night, like a real household.
One tap from anywhere. Works alongside WIS alarms and cameras.
This is how a lighting system becomes a security system.
Not a translated menu. Every room, every device and every fault message has a real name in both languages. One tap switches the whole app — and the wall panel follows.
Same house, same moment, two languages. Also available in both languages on video.
A flickering light is not an app problem. One module at 31.8 V is a hardware problem — and we see it weeks early.
5750WPL · module 75 reads 31.8 V — every other module reads 32.0–34.1 V. Manufacturer range is 32–38 V. Trend is still collecting.
What to do: a 15-minute check is enough to confirm it. Send the report and we will book a visit — with the serial number already on the ticket.
Real screen · 18 High St, Oct 2026
Two short films — one English, one Chinese — plus a 30-second vertical cut for social.
Straight answers on cost, hardware, and what happens when the original installer disappears.
Yes. WIS Living connects through a C-Bus USB PC interface (5500PCU) or a network bridge (5500CN / CNI). Your keypads, dimmers and wiring stay as they are — you gain control on iPhone, iPad and Android.
Installation is a one-off $699 for homes up to 30 channels, $999 for 31–70 channels and $1,599 for 71–120 channels, assuming a 5500PCU or 5500CN/CNI is already fitted. Care plans start at $59 per month and include the app, a daily system check and fault notices.
Yes. We fault-find and replace failed C-Bus hardware including 5750WPL dimmers, 5750PSU power supplies, 5500CN network bridges and 5500PCU interfaces. We identify the failing module by voltage reading and serial number rather than guessing.
Yes. We read the existing project, rebuild the database where needed, and document every room, circuit and scene. Systems installed between 2003 and 2015 are our specialty.
No. C-Bus is now Schneider Electric SpaceLogic C-Bus and is still manufactured and supported. What usually disappears is the local dealer who programmed your system — that is the gap WIS Living fills.
Yes. The brain sits in the house. Schedules, scenes and wall panels keep working during an internet outage; remote access runs through WIS rather than open ports.
Yes. C-Bus relays and dimmers can switch or dim lights, blinds and fans, and run presence schedules that make an empty house look occupied. It also works alongside WIS alarms, cameras and access control.
We service Greater Melbourne, including Box Hill, Melbourne CBD, Doncaster, Templestowe, Balwyn, Kew, Hawthorn, Camberwell, Glen Waverley, Mount Waverley, Burwood, Brighton, Toorak, South Yarra, Ivanhoe, Essendon and Point Cook.
Most homes are completed in one visit of three to five hours. Systems with 70+ channels are usually split over two visits, and the app is handed over with every room named and tested.
Based in Box Hill, working across Greater Melbourne. If your suburb is not listed, ask — we travel for whole-home C-Bus work.
WIS Security Group Pty Ltd · VIC Master Security Licence 967-112-21S · ASIAL member 39793 · Site 10, 17 Market Street, Box Hill VIC 3128 · 1300 008 818
Page updated 26 October 2026.
Need a full C-Bus design, installation or building-wide automation? See C-Bus building automation Melbourne.
The app is included. The monthly fee is the service.
| Installation (one-off) | Channels | From |
|---|---|---|
| Standard | ≤ 30 | $699* |
| Medium | 31–70 | $999* |
| Large | 71–120 | $1,599* |
* Price assumes the property already has a C-Bus USB PC interface (5500PCU) or a C-Bus network bridge (5500CN / CNI). If not, hardware and additional installation are quoted separately.
One account, every site. At home it talks straight to Canopy. Away, through our relay. No open ports.
Demo requires the WIS Tailscale network. Client portal: login.wisliving.com.au — coming with the VPS move.
Sign in to your home
No password. A 6-digit code, valid for 5 minutes.
Protected by device keys · No inbound ports
A 45-minute walkthrough at your place: we read the existing system, show the app on your own phone, and leave you with a fixed quote.
WIS Living is a WIS Security product · Melbourne, Victoria